Description

JTX G3 Battery Cable No Need Flash Ios 18-Ip15p/pm

Uses of JTX G3 Battery Cable (No Need Flash, iOS 18 - iPhone 15P & iPhone 15PM Series)

The JTX G3 Battery Cable is a specialized tool designed for the iPhone 15P & iPhone 15PM series, enabling battery management without requiring flashing. It is essential for mobile technicians and repair professionals.

Features:

• JTX gen 3 no need flash iOS18 special battery cable, for iPhone 12 or higher support run diagnostics/iOS18 no need flash

• Simple operation, no host required

• One-piece molding is easier to operate, durable, and reusable

• Make it easy to operate a newly upgraded one-piece process battery repair cable

Please Note:

• Support iOS: 15~17.3 old system, plug in the data cable and start the machine, wait for the charging logo to appear in the upper right corner, turn off the machine and wait for 5 seconds before turning it on again, enter the system and check the battery 100%, the repair is complete

• Supports 17.4 or above system, can be Flashed by software such as AlSl, 3utools, and so on
• Default 100%, automatically read the original machine cycle and other powerful features to avoid Flash showing red, iPhone 12 or more models,18.1 or more system support for Flash-free repair battery 100%
• Another original disassembled battery is loaded into the phone, battery diagnostics are complete, and then the battery is installed with the old original battery flex. For the second diagnostic, after the completion, the phone is 100%

• Do not connect the 3utools in the middle; wait to install the original battery after the diagnosis is completed (to avoid turning red)

• Pay attention to the end of the motherboard, and press gently to avoid damage.

JTX G3 Battery Cable No Need Flash Ios 18-Ip15p/pm – FAQ

Q1: What is the JTX G3 Battery Cable used for?

A: It is used to activate, test, or boot up iPhone 15 Pro / 15 Pro Max batteries outside the phone—ideal for technicians doing battery replacements, logic board work, or diagnostic tests.

Q2: Is this cable compatible with iOS 18?

A: Yes, the JTX G3 is fully compatible with iOS 18 and supports all updates without needing firmware flashing or extra steps.

Q3: What does “No Need Flash” mean?

A: It means you do not need to flash or reprogram the battery when using this cable. Just connect it, and it works—saving time and reducing the risk of software-related errors.

Q4: Which iPhone models are supported?

A:

• iPhone 15 Pro (IP15P)

• iPhone 15 Pro Max (IP15PM)

Q5: Do I need any additional tools or software?

A: No. The cable is plug-and-play. No additional flashing tools, software, or battery data transfer tools are needed.